A review paper on development of optimum machining parameters tool for different workpiece material
Milind Dasharath Telore
, Prof. G. E. Kondhalkar
Cutting Speed, Depth of Cut, Feed Rate, Force, MRR, Surface Finish, Finite Element Analysis
In this, we work on cutting forces at a single point cutting tool-tip interface is determined. An investigation of cutting forces acting on the tool is carried out by subjecting it to the maximum possible working stress during a cutting operation. It is also determined that a change in cutting speed and depth of cut has the maximum effect on increasing cutting forces. By varying the material, the effect of those on cutting forces is compared with the experimental results and FEA results. The experimental results reveal that the main factors responsible for increasing cutting forces are cutting speed (v), feed rate (f), and depth of cut (d), respectively. In this paper, a FEM simulation technique is utilized to investigate the physical cutting and deformation of the tip of a single-point cutting tool under the influence of cutting forces.
"A review paper on development of optimum machining parameters tool for different workpiece material", IJSDR - International Journal of Scientific Development and Research (www.IJSDR.org), ISSN:2455-2631, Vol.8, Issue 4, page no.912 - 914, April-2023, Available :https://ijsdr.org/papers/IJSDR2304155.pdf
Volume 8
Issue 4,
April-2023
Pages : 912 - 914
Paper Reg. ID: IJSDR_205216
Published Paper Id: IJSDR2304155
Downloads: 000347191
Research Area: Mechanical Engineering
Country: Pune, Maharashtra, India
ISSN: 2455-2631 | IMPACT FACTOR: 9.15 Calculated By Google Scholar | ESTD YEAR: 2016
An International Scholarly Open Access Journal, Peer-Reviewed, Refereed Journal Impact Factor 9.15 Calculate by Google Scholar and Semantic Scholar | AI-Powered Research Tool, Multidisciplinary, Monthly, Multilanguage Journal Indexing in All Major Database & Metadata, Citation Generator
Publisher: IJSDR(IJ Publication) Janvi Wave
